Phlatboyz.com
THE BUILD
Tools Required for Phlat-BoneZ and Phlat-PremiuM Kits
Hammer
Wrench
Small flat head screw driver
Phillips head screw driver
Drill with 1/8" and 1/16" Bit (Phlat-BoneZ) will also need a 1/4" Bit
Razor knife (Phlat-Bonez)
Wire strippers (Phlat-BoneZ)
Wood Glue and Super Glue
Phlat-PremiuM and Phlat-BoneZ Component Assembly and Finalization Videos
* Everyone, regardless of which Kit you purchased, needs to complete the following steps*
Work your way down through the videos to complete the component assembly
This steps has you clean the factory grease from the (2) black iron pipes.
PhlatboneZ__PhlatPremium_Step1.wmv
Windows Media video format [15.5 MB]
This is the first part of the Drive Roller Assembly
PhlatboneZ__PhlatPremium_Step2.wmv
Windows Media video format [14.6 MB]
This is the second part in the Drive Roller Assembly
PhlatboneZ__PhlatPremium_Step3.wmv
Windows Media video format [15.8 MB]
This video will take you through the steps of Assembling the (2) Pressure rollers
PhlatboneZ__PhlatPremium_Step4.wmv
Windows Media video format [8.6 MB]
In this step you will be applying the Grip Tape to the Drive Roller.
PhlatboneZ__PhlatPremium_Step5.wmv
Windows Media video format [17.7 MB]
In this step you will be completing the Pressure Rollers by adding Grip Tape
PhlatboneZ__PhlatPremium_Step6.wmv
Windows Media video format [12.3 MB]
This next section will walk you through the process of building the Phlatprinter and adding all of the components we just assembled, as you go.
There will be pictures and video for each step to walk you through the entire process. Each video will be Trish and me building the Phlatprinter.
The pictures are really added for reference, the steps should be followed by using the videos.
Let's get it on!!!
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Step 16
Step17
Step 18
Step 19
Step 20
Step 21
Step 22
Step 23
Step 24
Step 25
Step 26
Step 27
Step 28
Step 29
Step 30
Step 31
Step 32
Step 33
Step 34
Step 35
Step 36
Step 37
Step 38
Step 39
Step 40
Step 41
Step 42
Finshed Build :)
CONRATULATIONS!!! You have completed the build of the Phlatprinter.
Now lets set up the software.
Put your Phlatprinter in the area close to the computer that you will be using with it.
Your parallel cable should reach the Driver card on the Phlatprinter. You should also be close to an electrial outlet.
Click here for the Next Step of setting up the Software.
print version
Recommend this page!